If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Here's where I stopped last night. I ran holes through both sides and put in the rough hardware (going to make it nicer over the weekend... the hardware is going to take the longest)
Well, I have been inspired, last night I made a mini scale model of my very own and it worked out surprisingly well considering I am usually useless at measuring, but the one you made just looks great. One thing that you mentioned about reinforcing the holes is something I have been wondering about too. How are you going to do that?
[quote user="kucejoe"]Well, I have been inspired, last night I made a mini scale model of my very own and it worked out surprisingly well considering I am usually useless at measuring, but the one you made just looks great. One thing that you mentioned about reinforcing the holes is something I have been wondering about too. How are you going to do that?
[/quote]
After I punched the holes it seems like it's heavy duty enough that no reinforcements will be necessary. As long as you're careful enough to punch all the holes in the same horizontal plane so that they all carry equal weight, there shouldn't be much pulling. Plus, essentially 3 layers of rough cotton canvas is pretty damn sturdy/heavy duty!
Comment